ELSNER 70149 70149 KNX CP IP, KNX TP to IP Router

70149 KNX CP IP, KNX TP to IP Router
 
- The coupler connects KNX TP with IP/Ethernet and filters the telegrams topologically and group-oriented.
- For commissioning, configuration, visualisation, logging and diagnosis of KNX devices
- Browser-based front end for reading out data and activating certain functions
The KNX TP to IP Router connects both media KNX IP and KNX TP. As KNX IP Router, it couples KNX IP/Ethernet and TP bus system. KNXnet/IP routing and tunnelling are supported. KNX CP IP is able to filter the traffic according to the installation place in the bus system hierarchy and according to the built-in filter tables for group-oriented communication. Configuring from the subline can be disabled. For KNX devices, KNX CP IP provides commissioning, configuring, visualization, protocolling and diagnostic operation. Operational and filtering states, malfunction and faulty communication are indicated by LEDs. To ease commissioning by short-time access to other lines, filtering can be temporarily deactivated on a single Function button press. Long messages with up to 240 bytes APDU length are supported.
KNX CP IP is shown in the network. With a browser a comfortable front-end can be accessed to read out device settings, remotely activate functions (like Programming Mode) and watch a 60 min busload history diagra . Also, the integrated bootloader function enables remote firmware updates via IP/Ethernet. Supplied by the KNX bus line, the device does not require an additional power supply. KNX IP devices can be connected by a standard RJ45 connector directly, and also via Ethernet networks.

Data sheet
Manual